(7) Move the M7E-PCB Main Control Board (2) in the direction of arrow to disconnect it from the power supply/sensor board (3).
(8) Remove the connector FAN, and disconnect the fan motor (4).
(9) Remove the M7E-PCB Main Control Board (2), together with the PCB guide plate (remove the fan motor (4) at the same time).
(10) Remove three screws (8) and remove the PCB guide plate (7) from the M7E-PCB Main Control Board (2).
Note:
When reinstalling the M7E-PCB (2) onto the guide plate (7), be careful not to bend the base plate (it is desirable to place a block underneath it to prevent