How To - Life Fitness 95L Service Manual

Models 95L, 95LWEZ, and 95LE Summit Trainers

How To...

HOW TO... REPLACE THE CONTROL LINK ASSEMBLY
Tools required: Phillips screwdriver, metric Allen set, snap ring pliers
Estimated repair time: 30 minutes
1. Remove the main shroud assembly (see "How To..." on page 86).
2. Remove the rocker arm cover (see "How To..." on page 92).
3. Remove the lever joint cover assembly (see "How To..." on page 93).
4. Remove the control link cap where the control link attaches to the pedal adaptor.
5. Remove the Allen bolt and washer that secure the control link assembly to the pedal
adaptor.
6. Remove the snap ring that holds the rocker arm to the control link shaft.
7. Carefully remove the control link assembly from the Summit Trainer. Note the
orientation of the thrust washer and hardened washer when separating the rocker arm
from the control link assembly.
8. Reverse steps 1 through 6 to install the new control link assembly.
Rocker Arm Cover
Snap Ring
Hardened Washer
102
Control Link Assembly
Thrust Washer
Clevis Cover
Rocker Arm
Allen Bolt,
Control
torque to
Link
20-30 ft-lbs
Cap
(30-41 Nm)
Lever Joint Cover
Washer