Other Operations; Changing The Video Colour System; Hi-Fi Stereo Sound System - FUNAI WD6D-D4413DB Owner's Manual

Other Operations

VCR VCR
To cue or review picture during playback
(Picture Search):
Press [FWD D] or [REV E] during playback.
Press it again and the unit will search in super high speed (in
the LP mode only).
To freeze the picture on TV screen during playback
(Still mode):
Press [PAUSE F]. Each time you press the button, the picture
will be forwarded frame by frame.
If the picture begins to vibrate vertically during the still mode,
stabilise the picture by pressing the [PROG.
picture is distorted or rolling vertically, adjust the vertical hold
control on your TV, if equipped.
To reset the tape counter:
Press [CLEAR].
To play back in slow forward motion:
During playback, press [PAUSE F], then press [FWD D].
If the noise bars appear on the TV screen, you can reduce it
by pressing [PROG.
VCR mode.
Note
• Still / Slow / Pause mode will be automatically cancelled
after 5 minutes to prevent damage to the tape and the video
head.
• To return to normal play back from the Picture Search / Still /
Slow mode, press [PLAY B].
72
EN
]. If the
]. Slow reverse is not available in

Changing the Video Colour System

This unit will distinguish the video colour system (SECAM,
PAL or MESECAM) automatically according to the format of a
pre-recorded video tape during playback or the input signal
from the tuner or external devices.
To change the video colour system manually, press
[SYSTEM].
Each time you press [SYSTEM], the colour system will
change as follows.
AUTO SECAM
Note
• If the playback picture on the TV screen is black and white,
change the video colour system manually.
• When you change the video colour system manually, be
sure to change it before recording. If you select the wrong
video colour system for recording, the colour of the picture
may be deteriorated.

Hi-Fi Stereo Sound System

This unit will record and playback Hi-Fi stereo sound.
In addition, it has an A2 and NICAM stereo sound decoder.
This unit will receive stereo and bilingual broadcasts and it is
possible to record in several ways and to play back the sound.
Selecting the Audio Mode
You can select each mode by pressing [AUDIO] on the
remote control. Each mode is indicated on the TV screen as
following.
Audio mode during playback of the recorded tape in Hi-Fi
mode:
Mode Audio output
Stereo Stereo
L L audio from both speakers
R R audio from both speakers
Normal Monaural
Audio mode during reception of bilingual broadcasts:
Mode Audio output
Main Main audio from the both speakers
Sub Sub audio from the both speakers
Main / • Main audio from the left speaker
Sub • Sub audio from the right speaker
Note
• If you play back non-Hi-Fi tapes, the unit will play back
automatically in monaural even if you select any mode.
• If the stereo signal becomes weak, the broadcast is
automatically recorded in monaural.
PAL MESECAM
Display on the
TV screen
STEREO
LEFT
RIGHT
MONO
Display on the
TV screen
Main
Sub
Main
Sub