Adjusting Engine Speed (Kohler-Powered Units) - Hobart 1435 Owner's Manual

7-4. Adjusting Engine Speed (Kohler-Powered Units)

Top View
Tools Needed:
OM-498 Page 26
3
After tuning engine, check engine
speeds. See table for proper no
load speeds. If necessary, adjust
speeds as follows:
2000 150 rpm
Start engine and run until warm.
Weld/Power Speed
Adjustment
3720 50 rpm (60 Hz)
1 Throttle Control Lever
2 Adjustment Screw
Move lever to Run (far right) posi-
tion. To increase speed, turn screw
out (counterclockwise) while lightly
pushing lever to the right. To de-
crease speed, turn screw in (clock-
wise).
Idle Speed Adjustment
3 Adjustment Screw
Move lever to idle (far left) position.
To increase idle speed, turn screw
in (clockwise). To decrease idle
speed, turn screw out (counter-
clockwise).
Y Stop engine. Close fuel
valve.
Top View
2 1
802 512-A / Kohler Dwg.