Adjusting The Presser Solenoid Position; (Solenoid Specifications) - Brother KE-430B Service Manual

５-２２. Adjusting the presser solenoid position (Solenoid specifications)
3457Q
3480Q
1. Remove the top cover (1) and the work clamp arm assembly (2).
Remove the top cover (1) and the button clamp assembly (2). [BE-438B, 438C]
2. Remove the two rubber caps (3), and loosen the two screws (4) of the solenoid setting plate B.
3. Loosen the four screws (5), set the presser solenoid (6) so that it is 110 ± 0.2 mm from the edge of the arm,
and then tighten the screws (4) and (5) in that order.
Note:
If this adjustment is not done correctly, the work clamp may not lift or drop and error E-60 may be displayed.
<KE-432B, 432C>
KE-430B, 430C series
5. ADJUSTMENT
<BE-438B, 438C>
Seen from above
3481Q
124