Remote And System Operations; Passive Arming/Locking; Warn Away ® Response; Triggered Response - Directed Electronics SmartStart 5000-series Owner's Manual

Security and remote start system

Hide thumbs Also See for SmartStart 5000-series:

Table of Contents

Remote and System operations

The system can be programmed to arm/lock itself au to mat i cal ly (called

pas sive arming/locking). If the system is programmed for passive arming/

locking, it will automatically arm/lock 30 seconds after the ignition is

turned off and the system detects that you have left the vehicle by opening

and closing a door. Whenever the system is in its 30-sec ond passive arm-

ing/locking count down, the status LED will ﬂash twice as fast as it does

when the system is armed/locked. At the 20-second point of the count-

down, the siren/horn will sound to indicate that the system is about to

arm/lock. At the 30-second point, the parking lights will ﬂash to indicate

that the system is armed/locked.

Note: If any protected entry point (such as a door or a switch-protected

trunk or hood) is open, the system will not passively arm/lock (unless

forced passive arming/locking is programmed on). See Programming

Options section in the expanded version of this manual online at www.

automatecarsecurity.com..

Warn away

response

A Warn Away Response consists of an alarm page along with the

responses described below.

•

Shock Sensor - Light impacts to the vehicle will ﬂash the vehicle

lights and sound the siren/horn for a few seconds.

A Triggered Response can be activated by any of the triggers listed

below. The default Triggered Response duration is 30 seconds but can

be programmed from 1-180 seconds by your installer.

Table of Contents

Smartstart 5000 series