System Override - Directed Electronics SmartStart 5000-series Owner's Manual

If the system is triggered and the siren has been sounding for longer
than six seconds, pressing
keeping the system in the armed state. The system does not disarm,
but resets. Pressing
system.
If the system is triggered and the siren has been sounding for less than
six seconds, pressing
provided for your convenience, in case the system is accidentally trig-
gered.

System Override

If your remote control is lost or damaged, you can manually disarm your
vehicle security system or disable an optional starter kill. To disarm or
disable the system without a remote control, you must have the vehicle's
ignition key.
To disarm/disable the system:
1. Turn the ignition to the ON position.
2. Press the control center button the preset number of times (one to
five times) within 15 seconds. The factory default setting is 1 press.
After five seconds, the sys tem will disarm/disable. If the system
does not disarm/disable, you may have waited too long. Start
over by turning the ignition off and on.
Number of Presses_____________________________________
Important:
The control center button can be programmed to
respond to 1-5 presses for the disarm/disable function. You
must check with the installer to verify the programming for your
individual unit.
© 2010 Directed Electronics. All rights reserved.
on the remote silences the siren while
again after silencing the system will disarm the
disarms the system. The six second timer is
11