Chapter 3—Starting Up
Switching On the Printer
Before switching on the printer, make the necessary connections, insert
any memory card you want to use, and check that the printhead is
engaged.
Switch on the power using the On/Off switch on the rear plate. The
"Power" control lamp on the front panel lights up when the power is on.
Wait for a few moments, while the printer loads the program and runs
some self-diagnostic tests:
Starting
After a short time, the printer is initialized. The progress of the initializa-
tion is indicated by an increasing number of colons on the lower line in
the display:
Initializing
:::
When the initialization is completed, a label is fed out. The following
message appears, indicating that the printer is ready for operation.
IPL 2.30
The message indicates the IPL version number.
18
Intermec EasyCoder PM4i—User's Guide (IPL version)