Intermec EasyCoder PM4i User Manual page 96

Chapter 11—Adjustments
In the Test/Service part of the Setup Mode, you can test the label stop
sensor if you have a detection problem.
The menu only provides indications from the label stop sensor unit.
The testing menu can determine if the sensor unit is not physically in
position, is blocked by dust or stuck labels, or is defective in some way.
Furthermore, this is an aid if media has detection complications.
Note: There is no way to adjust the LSS-function; the menus
only indicate values obtained from the LSS.
• Check that the printer is set up for the type of media loaded in your
printer (Setup Mode→Media→Media type→Gap, Mark, or Continu-
ous.
• Lift and lower the printhead, then press the <Feed/Pause> key.
• Make sure that there is a label—not a gap or mark—at the LSS.
• Check that the media is routed as close to the center section as the
guides allow.
• Enter the Setup Mode (see Chapter 7) and go to Setup Mode→Test/
Service→LSS Test→LSS Auto.
• The menu should look like this with the cursor placed in the center:
LSS Auto
• Gap detection:
Lift the printhead and pull out the media slowly. When the LSS
detects a gap or a detection slot, the cursor moves to the right.
LSS Auto
• Mark detection:
Lift the printhead and pull out the media slowly. When the LSS
detects a black mark, the cursor moves to the left.
LSS Auto
• It is possible to refresh the centered cursor position by pressing the
< > key.
84 Intermec EasyCoder PM4i—User's Guide (IPL version)