Tickets With Gap - Intermec EasyCoder PM4i User Manual

Tickets with Gaps
⇐ a ⇒ Media Width
Maximum:
Minimum:
⇐ b ⇒ Copy Length
Max. length between slots: depends on SDRAM size
Min. length between slots:
Under ideal circumstances, a minimum ticket length of 4 mm (0.16
inches) could be used. It requires the sum of the copy length (b) and
the detection slit height (e) to be larger than 7 mm (0.28 inches), that
batch printing is used, and that no pull back of the media is performed.
Intermec does not guarantee that such short tickets will work, but it is
up to the user to test this in his unique application.
⇐ c ⇒ LSS Detection Position
Variable, see Chapter 11.
⇐ d ⇒ Detection Slit Length
The length of the detection slit (excluding corner radii) must be mini-
mum 2.5 mm (0.10 inches) on either side of the LSS detection position
(e).
⇐ e ⇒ Detection Slit Height
Maximum:
Recommended:
Minimum:
Media Type Setup
• Gap
Note: Do not allow any perforation to break the edge of the
media as this may cause the media to split and jam the printer.
Intermec EasyCoder PM4i—User's Guide (IPL version)
Appendix B—Media Specifi cations
114.3 mm (4.50 inches)
25.0 mm (1.00 inches)
8.0 mm (0.32 inches)
21.3 mm (0.83 inches)
1.6 mm (0.06 inches)
1.2 mm (0.05 inches)
99