Section 10-Shroud/Wheels; Replacing The Flat Free Tires On The Wheel Rim; Removing/Installing The Shrouds; Removing - Invacare Pronto M94 Owner's Manual

With surestep

Hide thumbs Also See for Pronto M94:

Table of Contents

SECTION 10—SHROUD/WHEELS

After ANY adjustments, repair or service and BEFORE use, make sure that all

attaching hardware is tightened securely - otherwise injury or damage may result.

Before performing any maintenance, adjustment or service verify that ON/OFF

switch on the joystick is in the OFF position.

REPLACING THE FLAT FREE TIRES ON THE

WHEEL RIM

DO NOT attempt to replace flat free tires. This procedure MUST be performed by

a qualified technician.

NOTE: During initial use of the wheelchair, the user may experience flat spots on the wheels. Flat

spots will vanish with continued use of the wheelchair.

NOTE: For this procedure, refer to FIGURE 10.1.

1. Remove the seat. Refer to Removing/Installing the Seat Assembly on page 41.

2. Perform one of the following:

A. TOP SHROUD - Lift UP on rear edge of top shroud to release the four (4) hook

and loop strips that secure the top shroud to the base frame as shown in Detail "A"

of FIGURE 10.1.

B. FRONT SHROUD - Turn release knob ¼-turn to the unlocked position and lift UP

to remove front shroud from base frame hooks as shown in Detail "B" in FIGURE

10.1.

™

Pronto

M94

WARNING

Part No. 1122145

Table of Contents

Show Quick Links

Table of Contents

Troubleshooting