Schwinn a10 Owner's Manual page 25

Console shuts off (enters
sleep mode) while in use
Unit rocks/does not sit
level
Pedals loose/unit difficult
to pedal
Clicking sound when
pedaling
Seat post movement
Check data cable integrity
Check data cable
connections/orientation
Reset machine
If bike has batteries, check
Battery Level icon on console
or check batteries.
Check magnet position
(requires shroud removal)
Check RPM Sensor
Check leveler adjustment
Check surface under unit
Check pedal to crank
connection
Check pedal to crank
connection
Check locking pin
Check adjustment knob
All wires in the cable should be intact. If any are cut or
crimped, replace cable.
Be sure cable is connected securely and oriented properly.
Small latch on connector should line up and snap into
place.
Unplug unit from electrical outlet for 3 minutes. Reconnect
to outlet.
If the battery level shows low or no power, replace the bat-
teries.
Magnet should be in place on pulley.
Contact Customer Care for further assistance.
Leveling feet may be turned in or out to level bike.
Adjustment may not be able to compensate for extremely
uneven surfaces. Move bike to level area.
Pedal should be tightened securely to crank. Be sure con-
nection is not cross-threaded.
Remove pedals and reattach fully.
Be sure adjustment pin is locked into one of the seat post
adjustment holes.
Be sure knob is securely tightened.
25