How To Set Up Ipv6 Interfaces For Pure Ipv6 Routing - ZyXEL Communications ZyWALL USG100-Plus User Manual

2.5 How to Set Up IPv6 Interfaces For Pure IPv6 Routing

This example shows how to configure your ZyWALL Z's WAN and LAN interfaces which connects two
IPv6 networks. ZyWALL Z periodically advertises a network prefix of 2006:1111:1111:1111::/64 to
the LAN through router advertisements.
Note: Instead of using router advertisement, you can use DHCPv6 to pass the network
settings to the computers on the LAN.
Figure 20 Pure IPv6 Network Example
2006:1111:1111:1111::/64
2.5.1 Setting Up the WAN IPv6 Interface
In the CONFIGURATION > Network > Interface > Ethernet screen's IPv6 Configuration
1
section, double-click the wan1.
The Edit Ethernet screen appears. Select Enable Interface and Enable IPv6. Select Enable
2
Stateless Address Auto-configuration (SLAAC). Click OK.
Note: Your ISP or uplink router should enable router advertisement.
ZyWALL USG100-PLUS User's Guide
Z
LAN WAN
IPv6
Chapter 2 How to Set Up Your Network
IPv6
IPv6
27