Table of Contents
Advertisement
OVER SCAN
(HDMI INPUT ONLY)
Tag6
USB SELECTION
POWER
MANAGEMENT
Tag7
LANGUAGE*
1
OSD H.POSITION
OSD V.POSITION
OSD TURN OFF
1
*
This item will not be reset during a FACTORY PRESET.
Some video formats may require different scanning modes in order to best display the
image.
ON: Image size is larger than what can be displayed. The image edge will appear
cropped. Approximately 95% of the image will be shown on the screen.
OFF: Image size stays within the display area. The whole image is displayed on the screen.
AUTO: Auto setting.
USB UP Stream Port Selection for DP/HDMI/DVI-D/D-SUB. When connecting a computer
to each of the upstream ports, the monitor's USB downstream ports can be used by
selecting this setting for the current input signal. When using only one upstream port, the
connected upstream port is active. You can change the active display and upstream USB
port combination by using the Input button (see page 12).
NOTE: To avoid data loss, before changing USB upstream ports, ensure that no USB
storage devices are in use by the operating system of the computer attached to the USB
upstream port.
Sets the power saving mode.
HUMAN SENSING: HUMAN SENSING has three settings:
OFF: No human sensing.
DEEP: After it is detected that there is no person, the monitor shifts to power saving
mode automatically.
When a person comes near the monitor again, it resumes from the power saving
mode and displays the images.
LIGHT: After it is detected that there is no person after a period of time, the monitor
shifts to low brightness mode automatically to reduce the power consumption. When
a person comes near the monitor again, the monitor will automatically return to normal
mode.
SENSITIVITY: SENSITIVITY has three settings.
NORMAL: Detects a person within about 80 cm from the monitor.
NEAR: Sensitivity is decreased.
FAR: Sensitivity is increased.
START TIME: Adjusts the wait time to react. (minute)
(SENSING STATUS): Displays the Sensing Status on the bottom of the OSD.
The Sensing Status is only displayed when the cursor is placed on SENSITIVITY.
The Sensing Status does not change when HUMAN SENSING is OFF.
When the monitor detects a person leaving from the monitor, the color gauge exceeds
the left arrow on the bar.
When the monitor detects a person approaching to the monitor, the color gauge
exceeds the right arrow on the bar.
NOTE: The monitor may not detect a person in a resting state and shift to power
saving mode.
The detection range is within about 80cm from the monitor when SENSITIVITY is set
NORMAL.
The monitor may not detect a person out of the detection range.
OFF MODE: The Intelligent Power Manager (IPM) in the computer's operating system
allows the monitor to switch to power save mode after a period of user inactivity. See
Page 15.
OFF MODE SETTING: Adjusts the ILLUMINANCE value for OFF MODE. Shows the
illuminance level.
The OSD control menus are available in nine languages. Press "LEFT" or "RIGHT" to
select.
You can choose where you would like the OSD control menu to appear on your screen.
Selecting OSD Location allows you to manually adjust the position of the OSD control
menu left or right.
You can choose where you would like the OSD control menu to appear on your screen.
Selecting OSD Location allows you to manually adjust the position of the OSD control
menu up or down.
The OSD control menu will stay on as long as it is used. You can select how long the
monitor waits after the last touch of a button to shut off the OSD control menu.
The preset choices are 10-120 seconds in 5 second increments.
English-23
Advertisement
Table of Contents
