NEC MD242C2 Installation & Maintenance Manual page 10

4. Connect all cables to the appropriate connectors (Figure C.1). When using the USB cable, connect the B type connector
to the USB upstream port on the right back side of the monitor and the A type connector to the downstream port on the
computer (Figure C.1a). If using the cord from a USB device, plug into one of the downstream ports of the monitor.
NOTE: Incorrect cable connections may result in irregular operation, damage display quality/components of the LCD module
and/or shorten the module's life.
NOTE: Up to 5 sub monitors can be daisy-chained.
NOTE: HDMI audio is not supported.
USB downstream
Highest
Stand
Position
USB downstream
USB upstream1
USB upstream2 USB upstream2
HDMI
DVI-D
DisplayPort D-SUB
(MD242C2)
5. To keep the cables neatly organized, place them into the cable management system that is built into the stand.
Place the cables in the hooks fi rmly and evenly (Figure C.2 and Figure C.3).
6. Please check that you can still rotate, raise and lower the monitor screen when you have installed the cables.
USB Cable
DisplayPort
Cable
DVI-D Cable
1
* Cable not included.
2
* Connect sensor to this port for self calibration (MD302C4 only).
30° Tilt
USB downstream*
USB downstream
USB upstream1
USB upstream2 USB upstream2
Power cord
Figure C.1
D-SUB Cable
Power Cord
(MD242C2)
30° Tilt
2
Highest
Stand
Position
DVI-D Mini DisplayPort
DisplayPort HDMI
(MD302C4)
USB Cable
DisplayPort
Cable* 1
DVI Cable
Mini DisplayPort
Cable
Figure C.2
English-8
B Type
B Type
Figure C.1a
Power cord
(MD302C4)
A Type
A Type
1
HDMI Cable*
Power Cord