Table of Contents
Advertisement
(MD242C2)
7. Slide down the cable cover (Figure D.1).
8. Connect one end of the power cord to the AC inlet on the back of the monitor and the other end to the power outlet.
NOTE:
Please refer to the Caution section of this manual for proper selection of an AC power cord.
9. Turn on the monitor with power switch on the top (Portrait) or left side (Landscape) of the
monitor (Figure E.1). Turn on the computer.
10. No Touch Auto Adjust automatically adjusts the monitor to optimal settings upon initial setup
for most timings. For further adjustments, use the following OSD controls:
• AUTO CONTRAST (Analog input only)*
• AUTO ADJUST (Analog input only)*
Refer to the Controls section of this User's Manual for a full description of these
OSD controls.
NOTE:
If you have any problems, please refer to the Troubleshooting section of this Manual.
Raise and Lower Monitor Screen
The monitor may be raised or lowered in either Portrait or Landscape mode.
To raise or lower the screen, place hands on each side of the monitor and lift or lower to the
desired height (Figure RL.1).
NOTE:
Handle with care when raising or lowering the monitor screen.
*
Only for MD242C2.
1
*
Cable not included.
Power Cord
D-SUB Cable
DVI-D Cable
DisplayPort Cable
USB Cable
Figure C.3
Figure D.1
Figure RL.1
English-9
Power Cord
HDMI Cable*
Mini DisplayPort
Cable
DVI Cable
DisplayPort Cable*
USB Cable
(MD302C4)
Power switch
Figure E.1
1
1
Advertisement
Table of Contents
