Table of Contents
Advertisement
Controls
OSD (On-Screen Display) control buttons on the front of the monitor
function as follows:
To access the OSD menu, press the MENU button.
The Key Guide appears pressing any button when not in the OSD control menu.
NOTE:
The OSD must be closed in order to change the signal input.
1 KEY GUIDE
2 AMBIENT LIGHT SENSOR
3 POWER
4 LED
5 Control Buttons
6 HUMAN SENSOR
7 FRONT SENSOR
6
7
2
3 4
A
5. Control Buttons
The Key Guide appears on the screen when the OSD control menu is accessed.
The Key Guide will rotate when the OSD control menu is rotated.
Perform along the notifi cation of each key.
NOTE: The KEY GUIDE appears as follows:
• KEY GUIDE when OSD menu is displayed.
• KEY GUIDE when OSD menu is undisplayed.
Each KEY GUIDE works as follows:
- Selects the item.
- Exits any OSD sub menu.
Exits the OSD Control menu.
- Resets the OSD back to factory settings.
- Changes the input source.
- Shows OSD menu.
- Shows USB SELECTION menu.
- Shows PIP MODE menu.
- Shows PICTURE MODE.
- Shows the quick screen QA test pattern.
Detects the level of ambient light, allowing the monitor to make adjustments to various
settings. Do not cover this sensor (See page 20).
Turns the monitor on and off.
Indicates that power is on.
A. INPUT button, SELECT button
B. EXIT button
C. LEFT/RIGHT button, MENU/USB button
D. UP/DOWN button, PIP/PICT button
E. RESET button, QA button
NOTE: When not in the OSD control menu, press the PIP button for at least 3 seconds to
display the quick screen QA test pattern (grayscale) drawing and check the display
performance.
Detects human presence in front of the monitor by infrared.
Do not cover this sensor (See page 23).
Detects screen luminance changes over time.
Used for luminance stabilization, standalone (Self Calibration, Gamma Adjust, DICOM
Measurement) and network (Gamma Adjust, DICOM Measurement) controlled calibrations
and conformance tests.
E
D
B
C
English-12
1
Advertisement
Table of Contents
