Table of Contents
Advertisement
Flexible Arm Installation
This LCD monitor is designed for use with a fl exible arm.
To prepare the monitor for alternate mounting purposes:
•
Follow the instructions provided by the manufacturer of the monitor mount.
•
To meet the safety requirements, the monitor must be mounted to an arm that supports the weight of the monitor.
See page 26-27 for details. Remove the monitor stand before mounting.
Remove the Monitor Stand for Mounting
To prepare the monitor for alternate mounting purposes:
1. Disconnect all cables.
2. Place hands on each side of the monitor and lift up to the highest position.
3. Place the monitor face down on a non-abrasive surface. Be sure to not apply any
stress or pressure to the integrated front sensor. To avoid this, lay the monitor face
down on a desk or table with the integrated front sensor situated off the edge
(Figure S.1).
4. Place one hand around the base and one hand on the Quick Release Lever.
Push and hold the Quick Release Lever in the direction indicated by the
arrows (Figure S.1).
5. Lift up the stand to unhook it from the monitor (Figure S.1).
The monitor can now be mounted using an alternate method.
Reverse process to reattach stand.
NOTE:
Handle with care when removing the monitor stand.
Mount Flexible arm
This LCD monitor is designed for use with a fl exible arm.
1. Follow the instructions on how to Remove the Monitor Stand for Mounting to remove the stand.
2. Use the 4 screws and attach the arm to the monitor (Figure F.1).
100 mm
Weight of LCD assembly: 6.8 kg (MD242C2)
Caution: Use ONLY the screws (4 pcs) that are included or the screws M4 size
(Length: thickness of bracket and washer + 10-12 mm) when mounting to
avoid damage to the monitor and stand. To fulfi l the safety requirements the
monitor must be mounted to an arm which guaranties the necessary stability
under consideration of the weight of the monitor. The LCD monitor should only
be used with an approved arm (e.g. GS mark).
NOTE:
Tighten all screws.
(The recommended torque is 0.98 - 1.37N•m)
100 mm
200 mm
100 mm
Weight of LCD assembly: 10.7 kg (MD302C4)
Figure F.1
English-11
Figure S.1
100 mm
Unit
Mounting Bracket
Washer
Screw
10-12 mm
Thickness of bracket
and washer
Advertisement
Table of Contents
