NETGEAR ProSafe Premium WNDAP620 Reference Manual page 51

ProSafe Premium 3 x 3 Dual-Band Wireless-N Access Point WNDAP620
Table 9. Profile definition settings (continued)
Setting
Broadcast Wireless
Network Name (SSID)
5. Specify the settings of the Authentication Settings section of the Edit Security Profile screen
as explained in the following table.
The wireless access point is set by default as an open system with no authentication.
When you configure network authentication, bear in mind the following:
• If you are using access point mode (which is the default mode if you did not enable
wireless bridging), then all options are available. In other modes such as bridge
mode, some options might be unavailable.
• Not all wireless adapters support WPA or WPA2. Windows XP, Windows 2000 with
Service Pack 3, and Windows Vista do include the client software that supports WPA.
However, client software is required on the client. Consult the product documentation
for your wireless adapter and WPA or WPA2 client software for instructions about how
to configure WPA2 settings.
Table 10. Profile authentication settings
Setting
Network Authentication
and Data Encryption
Note: The data
encryption fields that
display onscreen
depend on your
selection from the
Network Authentication
drop-down list.
Description
Select the Yes radio button to enable the wireless access point to broadcast its
SSID, allowing wireless stations that have a null (blank) SSID to adopt the
wireless access point's SSID. Yes is the default setting. To prevent the SSID
from being broadcast, select the No radio button.
Description
Open System This is the default setting. Use an open system without any
encryption or with WEP encryption.
See Configure an Open System with WEP or Shared Key
with WEP
Shared Key Use WEP encryption and enter at least one shared key.
See Configure an Open System with WEP or Shared Key
with WEP
Legacy 802.1X Configure the RADIUS server settings. Encryption is not
supported.
See Configure Legacy 802.1X
WPA with Radius Configure the RADIUS server settings and select TKIP or
TKIP + AES encryption.
See Configure WPA with RADIUS, WPA2 with RADIUS,
and WPA & WPA2 with RADIUS
WPA2 with Radius Configure the RADIUS server settings and select AES or
TKIP + AES encryption.
See Configure WPA with RADIUS, WPA2 with RADIUS,
and WPA & WPA2 with RADIUS
Note:
Wireless Configuration and Security
51
on page 53.
on page 53.
on page 54.
on page 55.
on page 55.
Select this setting only if all clients support WPA2.