NETGEAR ProSafe Premium WNDAP620 Reference Manual page 117

ProSafe Premium 3 x 3 Dual-Band Wireless-N Access Point WNDAP620
Note: Rate limiting for the wireless interface is an optional setting that
applies to all traffic on the wireless interface. Unlike classification
rate limiting, which you can specify for each classification, rate
limiting for the wireless interface needs to be specified only once.

To specify rate limiting for the wireless interface:
1. Specify rate limiting for the entire wireless interface as explained in the following table:
Table 35. Wireless interface rate limiting settings
Setting
Interface
Rate Limiting
2. Click Apply to save your settings.

To modify a QoS policy:
1. From the Create Policy drop-down list, select the policy that you want to modify.
2. To delete a classification, select it in the Classification field, and click Delete Classification.
3. To add a classification, follow
QoS policy. You can also change the name of the policy.
4. Click Apply to save your settings.

To delete a QoS policy:
1. From the Create Policy drop-down list, select the policy that you want to delete.
2. Click Delete Policy.
3. Click Apply to save your settings.
Description
Bits Per Sec. Enter a value between 0 and 300,000,000 bps to specify the maximum
data rate up to which packets are queued for transmission and sent
immediately over the wireless interface. This value applies to all traffic
on the wireless interface.
Note: When the maximum rate is exceeded, packets are retained in
the queue and sent when the transmission falls below the maximum
rate again.
Burst Rate Enter a value between 0 and 37,500,000 bytes to specify the maximum
(Bytes) amount of data that can be transmitted in a burst over the wireless
interface. This value applies to all traffic on the wireless interface.
Step 5 through
Advanced Configuration
Step 7 in the procedure to configure a new
117