NETGEAR ProSafe Premium WNDAP620 Reference Manual page 12

ProSafe Premium 3 x 3 Dual-Band Wireless-N Access Point WNDAP620
Figure 1.
Table 1. Top panel LEDs
Item LED Description
1 Power/Test Off
2 Active
3 LAN
4 2.4 WLAN
Ghz
5
5 WLAN
Ghz
2
1
On (green)
Amber, then blinking
green
Off
On or blinking (green) Ethernet traffic is detected.
Off
Amber
Green
Off
On or blinking (green) Wireless 802.11b/g/n (2.4 GHz) LAN is ready, or
Off
On or blinking (green) Wireless 802.11n/a (5 GHz) LAN is ready, or wireless
Introduction
12
3 4
Power is off.
Power is on.
A self-test is running or software is being loaded.
During startup, the LED is first steady amber, then
goes off, and then blinks green before turning steady
green after about 45 seconds. If after 1 minute the
LED remains amber or continues to blink green, it
indicates a system fault.
No Ethernet traffic is detected, or no link is detected.
10 Mbps or no link is detected.
10/100 Mbps link is detected.
1000 Mbps link is detected.
Wireless 802.11b/g/n (2.4 GHz) LAN is not ready, or
no wireless activity is detected.
wireless activity is detected.
Wireless 802.11n/a (5 GHz) LAN is not ready, or no
wireless activity is detected.
activity is detected.
5