Summary Of Test And Service Mode Commands - Intermec 4400 User Manual

NugFont
HelvC

Summary of Test and Service Mode Commands

table lists a summary of the available Test and Service mode commands. Each
command is described in detail later in this chapter.
Command Code Function Description
A Ambient Temperature, Transmit*
B Printhead Resistance Test, Begin
C Pitch Label, Print
D
Reset Printer Configuration
G
Gap Sensor Value, Transmit*
L
Label Path Open Value, Transmit*
M
Mark Sensor Value, Transmit*
P
Printhead Temperature, Transmit*
Q Print Quality Label, Print
R Test and Service Mode, Exit
S Printhead Resistance Values, Transmit*
T
Label Taken Value, Transmit*
U
12 Volt Supply Value, Transmit*
V
24 Volt Supply Value, Transmit*
;
Command Terminator
Note: Commands denoted by an asterisk (*) will not receive a reply when used with a
parallel interface.
C o d e 3 9
Printer Commands
7
The following
7-11