Intermec 4400 User Manual page 249

Error Message Problem
Some of the elements in the printhead are
printhead
not within the acceptable temperature
TESTED OUT OF
range.
RANGE
The six range errors are listed on the next
RANGE error
page. Press [CONTINUE] to clear the
alert.
Problem
12 Data count has been exceeded.
21 Quantity or batch count is out of range.
22 Increment or Decrement quantity is out
of range.
23 Intercharacter delay or message delay is
out of range.
52 Invalid font/graphic height, width, or
intercharacter gap.
If you are using the Cloning or Selective
RECEIVER ERROR
Transfer commands, the Receiver printer
is not receiving the information from the
Sender.
You are out of thermal transfer ribbon or
ribbon fault
it is jammed.
You do not have the same version of
ROM VERSION
software for the two processors. The
MISMATCH
printer will not power up.
NugFont
HelvC
C o d e 3 9
Troubleshooting
Solution
If printing has stopped but your labels
are satisfactory, you can continue
printing by setting the Printhead Test
command in the Configuration menu to
WARN - CONTINUE. If the label quality
becomes too poor, you may need to
replace the printhead. To adjust the test,
see "About the Printhead Test" in
Chapter 5.
Solution
Reduce the amount of data entered into
this field or increase the field's maximum
data (up to 200).
Quantity of labels should be between 1
and 9999 and there should be 1-9999
batches of labels.
Quantity should be between 1 and 9999.
Delay should be between 0 and 9999.
Font or graphic height and width should
be between 1 and 600. Intercharacter gap
should be between 0 and 199 dots.
Make sure the Receiver printer is turned
on and set up correctly for receiving
information from the Sender. Check all
connections between the Receiver and
the Sender printers.
Clear the jam or replenish the ribbon
stock (refer to Chapter 4). Press
[FEED/RELOAD] to clear the alert.
Contact your Intermec Product Support
Representative.
9
9-11