Scan Viewer Screen - Kodak PS50 Series User Manual

Scan Viewer screen

A-61760 September 2012
When you click Batch Scan, Flatbed Scan, Redo Batch or Redo
Flatbed Scan or Redo Scan, the Scan Viewer screen will be
displayed.
The screen will display images one at a time while scanning, then close
automatically when scanning is completed.
Pause Display/Continue Display — when selected, will hold the
currently displayed image. When selected again, will refresh to the
most recently scanned image.
Stop Scanner — when selected, scanning will stop. The Scan Images
or Enhance Picture screen will be displayed.
NOTE: If there are no photos in the feeder at the time Stop Scanner
was clicked, the scanner will continue to run until the transport
time out is reached and the Scan Images or Enhance Picture
screen will be displayed. To bypass long transport time outs,
place a photo in the scanner to transport it through the scanner,
the transport will then stop when the photo exits. This photo will
not be part of your batch of scanned images.
Return — returns to the Scan Images or Enhance Picture screen.
The Scan Viewer refresh rate may be adjusted to show every image or
to sample the scanned images from every image up to every tenth
image. The Scan Viewer screen may also be disabled. Refer to section
Application Configuration in Chapter 7 for more information.
3-9