Kodak PS50 Series User Manual page 46

4-8
6. Select the Image Cleaner Tool if you want the Picture Saver
Scanning System to attempt to eliminate any streaks in the back
side image after scanning.
7. Click Settings if you want to change any of the default scan settings
(i.e., mode, resolution, sharpen images, etc.).
NOTE: Within an order you can change the settings anytime before
starting a Batch or Flatbed scan.
8. Click Batch Scan or Flatbed Scan. The message Scanner lamps
are warming may be displayed. Scanning will start when the lamps
are ready (usually within a few seconds).
NOTES:
• If you are using an optional Kodak Legal Flatbed or Kodak A3
Flatbed, the photo must always be placed face down on the
platen.
• When Batch Scan is selected, you have 1 to 20 seconds to
place photos into the Picture Saver System Scanner depending
on the transport timeout value.
As photos are being scanned, the scanned images will be displayed
1-up in the Scan Viewer screen.
Pause the Scan Viewer display for an extended review of the image
currently displayed. The scanner will not stop.
To stop the scanner, pull the rest of the photos out of the feeder.
You will be returned to the Scan Images screen.
A-61760 September 2012