Getting Your Scanner Ready To Scan; Getting Your Pages Ready To Scan - Kodak alaris 2000w Series User Manual

3 Scanning

Getting your scanner ready to scan

Getting your pages ready to scan

18
1. Be sure the scanner is on and ready to scan (power button on and
not blinking).
2. Move the side guides in or out to fit the size of pages you are
scanning. If scanning letter or A4 size paper, the side guides may be
restricted to the maximum width of the paper using the switch in the
inset below on right. The switch is shown in the letter size position.
See "Preparing documents for scanning" step number 6 on page 30.
3. If necessary, adjust the input and output trays for the length of your
pages. The output tray can be extended to accommodate pages up
to 35.56 cm (14 inches) in length. An end stop is available to assist
output page stacking. Lift this end stop as needed for scanning
pages up to 14 in/35.6 cm. Keep the end stop down when scanning
longer pages. See "Long paper" on page 33.
Refer to the following sections for detailed help:
• "Input tray capacity" on page 29
• "Preparing documents for scanning" on page 29
Later sections of this chapter provide advice on how to scan hard
cards, batches of mixed size paper, NCR paper, etc.
Input tray
extension for
long documents
Output tray
extension and
end stop
A-61931 April 2021