Symbols - A&D UA-767PC Instruction Manual

Symbols

Turns on or off the device
Sets the clock / Does not store the current data
Direction guide to install battery
Direct current
SN Serial number
Date of manufacture
Type BF: Device, cuff and tubing are
designed to provide special protection
against electric shocks.
Appears when measurement is in progress
and flashes when the pulse is detected.
Previous measurement stored in MEMORY
Appears when the battery voltage is
too low for the device to work properly.
Appears if the systolic and diastolic
measurements are within 10 mmHg of
each other.
Appears if the pressure value is
unstable due to movement during the
measurement.
Appears if the pressure value did not
increase during pump up.
System error
Appears if pulses are not detected
correctly.
Attention symbol
SYS Systolic blood pressure in mmHg
DIA Diastolic blood pressure in mmHg
PUL./min Pulse per minute
EC directive medical device label
WEEE label
Manufacturer
EU-representative
EC REP
Refer to instruction manual/booklet
Class II device
Polarity of DC jack
Symbols
Function / Meaning
English 5
Treatment
Measurement is in progress --
remain as still as possible.
Replace all batteries with new
ones.
Verify that the air hose is
properly connected and that the
exhaust rate is between 2 and 5
mmHg. Check for air leakage.
Try the measurement again.
Remain very still during the
measurement.
Verify that the air hose is
properly connected and that the
exhaust rate is between 2 and 5
mmHg. Check for air leakage.
Remove the batteries. Install
them again properly.
Apply the cuff properly and try
the measurement again.
See instruction for use.