L2Tpserver - D-Link NetDefend DFL-210 Cli Reference Manual

3.30.7. L2TPServer

MPPERC4128
DialOnDemand
ActivitySensing
IdleTimeout
Metric
MTU
AutoInterfaceNetworkRoute
MPPEAllowStateful
MemberOfRoutingTable
RoutingTable
Comments
3.30.7. L2TPServer
Description
A PPTP/L2TP server interface terminates PPP (Point to Point Protocol) tunnels set up over existing
IP networks.
Properties
Name
IP
TunnelProtocol
Interface
ServerIP
UseUserAuth
MPPENone
MPPERC440
Use an RC4 128 bit MPPE session key with MS-CHAP or
MS-CHAP v2 authentication protocol. (Default: Yes)
Enable Dial-on-demand which means that the L2TP/PPTP
tunnel will not be setup until traffic is sent on the interface.
(Default: No)
Specifies if the dial-on-demand should trigger on inbound or
outbound traffic or both. (Default: BiDirectional)
Idle timeout in seconds for dial-on-demand. (Default: 3600)
Specifies the metric for the auto-created route. (Default: 90)
Specifies the size (in bytes) of the largest packet that can be
passed onward. (Default: 1456)
Automatically add a route for this interface using the given
remote network. (Default: Yes)
Allow usage of Stateful MPPE (less secure, use only for com-
patibility). (Default: No)
All or Specific. (Default: All)
Specifies the PBR table to insert the interface IP route into. It
also means that the specified routing table will be used for all
routing lookups, unless overridden by a PBR rule. (Default:
main)
Text describing the current object. (Optional)
Specifies a symbolic name for the interface. (Identifier)
The IP address of the PPTP/L2TP server interface.
Specifies if PPTP or L2TP should be used for this tunnel.
(Default: PPTP)
The interface that the PPTP/L2TP Server should be listening on.
Specifies the IP that the PPTP/L2TP server should listen on, this
can be an IP of a interface, or for example an ARP published IP.
Enable the use of user authentication rules on this server.
(Default: Yes)
Allow no authentication for this tunnel. (Default: Yes)
Use an RC4 40 bit MPPE session key with MS-CHAP or MS-
140
Chapter 3. Configuration Reference