D-Link DI-804 User Manual page 42

Refer to the fo llowing table for descriptions of the diagnostics pop-up
window.
LAN1 Status :
IP Address: IP address of the LAN1 interface.
TX Packets: Total number of transmitted IP packets sent since the
DI-804 was powered on.
RX Packets: Total number of received IP packets received since the
DI-804 was powered on.
LAN2/WAN Status :
Mode : Indicates which broadband access mode is active. Depending
upon the broadband access mode, you may see Static IP, Dynamic
IP, PPTP, or PPPoE.
GW IP Address: Indicates the gateway IP address.
IP Address: IP address of the LAN2/WAN interface.
TX Packets: Total number of transmitted IP packets sent during this
connection session.
TX Rate : Transmission rate for outgoing data. The unit is characters
per second (cps).
RX Packets: Total number of received IP packets received during this
connection session.
RX Rate: Reception rate for ingoing data. The unit is characters per
second (cps).
Up Time : Connection time. The format is HH:MM:SS where HH
means hours, MM means minutes, and SS means seconds.
Drop PPPoE or PPTP: Click the link to disconnect the PPPoE or
PPTP connection.
42