Installation; Working Angle And Range Of The Ir Blaster - Integra RFR-6 Instruction Manual

Installation

The following components should be present:
RF Receiver, power adapter, Mono cable, 3 IR
emitters, mounting plate and 4 screws.
Before you install the RF Receiver, you should
decide which of the set-ups described on p. 3 ap-
ply to your needs. It is recommended to read
through this manual entirely.
Working angle and range of the IR
blaster
The IR signals sent out by the RF Receiver al-
ways have to be able to reach the remote control
sensor of your devices. Make sure that the IR
blaster (dark plastic window on top of the RF
Receiver) is aimed at your devices.
To get optimal results, it is recommended to
place the RF Receiver horizontally with the IR
blaster facing up or down.
IR blaster facing down
Minimum distance: 4 inches
(10 cm)
Figure 1
Figure 1 represents the RF Receiver mounted up
side down inside a closet. Always maintain a
minimum distance of 4 inches (10 cm) between
the RF Receiver and your devices.
4
IR blaster facing up
Maximum distance: 16 feet (5 m)
Figure 2
Figure 2 represents the RF Receiver with the IR
blaster facing up. The RF Receiver can be placed
at a distance and higher than your devices. Make
sure there are no objects between the RF Re-
ceiver and the remote control sensor of the de-
vices.