Settings; Rf Interference - Integra RFR-6 Instruction Manual

Installation

Settings

As the RF Receiver "communicates" with the
RF Remote Controller, you have to set the same
Receiver ID (identity) on both appliances. The
settings depend on whether you have a single RF
Receiver or multiple RF Receiver.
Single RF Receiver
When you use only one RF Receiver, you can
accept the default setting for the Receiver ID
(ID=0). Make sure your RF Remote Controller is
set to the same default setting (see the RF Re-
mote Controller's manual for more details).
Multiple RF Receiver
If you want to operate several of your devices in-
dependently, e.g. grouped on different locations,
you will need multiple RF Receiver. When using
several RF Receiver, it is important to assign a
unique Receiver ID to each RF Receiver. 16 Re-
ceiver IDs (from 0 to 9 and from A to F) can be
assigned.
1 Choose an Receiver ID for the RF
Receiver by turning the ID dial with a
small screwdriver.
2 On the RF Remote Controller, choose
the same Receiver ID for each device
controlled by the RF Receiver.
Refer to the RF Remote Controller's manual
for more information.
8
3 Try to operate your devices with the
RF Remote Controller.
The red LED will blink when the RF Re-
ceiver receives a correct command.
4 Repeat this procedure for every RF
Receiver.

RF Interference

If your devices are not responding to commands
or if the red LED on the IR blaster is blinking
without sending commands, it might be possible
that there is RF interference. This can be the
case when other RF appliances are operated
nearby, for instance by your neighbours.
When you notice RF interference, you have to
choose another channel on your RF Receiver. 4
channels (CH from 0 to 3) can be assigned.
1 Choose a channel for the RF Receiver
by turning the CH dial with a small
screwdriver.
2 On the RF remote controller, choose
the same channel for each device
controlled by the RF Receiver.
Refer to the RF Remote Controller's manual
for more information.
3 Try to operate your devices with the
remote controller.