How To Use The Emitters; Connecting The Power Adapter - Integra RFR-6 Instruction Manual

Installation

How to use the emitters

The IR emitters can be attached to the surround-
ing surface facing the remote control sensor or
directly to the remote control sensor.
1 Attach the emitters to a surface
above, below or in front of the remote
control sensor of your devices (for
aesthetic appearance or when it is
difficult to locate the remote control
sensor).
–OR–
Attach the emitters directly to the
remote control sensor of your
devices.
2 Plug the IR emitters into the RF
Receiver.
To avoid interference, the wires of the emit-
ters should be kept away from the RF Re-
ceiver as far as possible.

Connecting the Power Adapter

When connecting the power adapter it is recom-
mended that you plug the adapter into the RF
Receiver before you plug it into the socket.
When connected you will see a red LED on the
RF Receiver.
Note:
To avoid interference, the adapter cable should
be kept away from the RF Receiver as far as
possible.
7