Troubleshooting - Integra RFR-6 Instruction Manual

Troubleshooting

Devices do not respond properly
■ Check if the power adapter is connected and
the red LED is on.
■ Check if the ID and channel numbers on the
RF Receiver match with the ID and channel
numbers on the RF Remote Controller (see
p. 8). Refer to the RF Remote Controller's
manual for more details on the settings of the
Remote Controller.
■ Check the placement of the RF Receiver:
• Check the distance between the RF Re-
ceiver and the RF Remote Controller (see
p.4).
• Check the range and the working angle of
the IR blaster (see p. 4).
• Check if the RF Receiver is placed in a
central position relative to your devices.
• Make sure that the distance between the
RF Receiver and your device is at least 4
inches (10 cm).
• Make sure that the distance between the
RF Receiver and your device is at most 16
feet (5 meters).
• Make sure the IR signals between the RF
Receiver and the remote control sensor of
your devices are not disturbed by any ob-
jects.
• Check if metal objects, for instance a
metal closet, wires or cables, surrounding
the RF Receiver do not disturb the RF sig-
nals.
• If you are using the 1/8 inch (3.5 mm)
mono cable, make sure to plug in all the
way to make a good connection.
• If you are using the IR emitters, make
sure they are connected properly and that
they are placed within range of the remote
control sensor (see p. 7).
■ It might be possible that some commands
cannot be sent out as RF signals. In that case
you will have to reconfigure the RF Remote
Controller to operate your devices with IR
signals again.
The red LED on the RF Receiver blinks
without using the RF Remote Controller
■ This indicates RF interference. Another de-
vice in the proximity is sending out RF sig-
nals. Change the channel (CH) on the RF
Receiver (see p. 8).
There is no red LED on my RF Receiver
■ Check if the power adapter is connected
properly.
The IR emitters are no longer adhesive
■ Replace the adhesive with a fresh piece of
the 2-sided tape.
I cannot find the exact location of the
device's remote control sensor
■ Check the manual of the device.
When still in doubt, contact your supplier or
the manufacturer.
9