System Requirements - Sagem MF 5890DN User Manual

Press the
Switch your terminal off and then back on again. You have now finished configuring the
IP address.
Manually configuring IP settings
You can make these settings when the TCP/IP protocol is on.
To configure your terminal manually, you will need the usual information for setting up a peripheral
(IP address, subnet mask and gateway address).
To manually configure network local settings:
Check that DHCP is set to
.
OK
Press
Press OK to enter the IP address. A cursor (_) starts to flash in the right-hand segment
figures). Press the
set the value for the right-hand segment, press the
Again, press the
same way for all of the segments. Press OK once all the segments have been set up.
Press
Enter the subnet mask address in the same way as for the IP address.
Press
Enter the gateway's IP address in the same way as for the IP address.
Press the
Switch your terminal off and then back on again. You have now finished configuring the
IP address.
Note: Other print-related settings are described in the Print Functions chapter.
You can configure the same settings either remotely or locally.

System requirements

To remotely configure your machine you will need:
• a Web browser (preferably Internet Explorer version 4),
• to make the Local Network settings for your machine (IP address, subnet mask, etc.). You should
ask your network administrator for these settings. Once you have this information, please see the
paragraph Local network settings, on page 3-11 on how to fill out the necessary fields.
key.
MENU
. If not press
OFF
.
key to increment the value and the
key to increment the value and the
.
.
key.
MENU
R
EMOTE CONFIGURATION
3-16
MENU - - INTERFACE > -
, then select
OK OFF
key to decrement it. Once you have
key to place the cursor in the next segment.
<
key to decrement it. Proceed in the
Setting your machine
- TCP/IP > DHCP
with the or keys. Press
(3