Removing And Installing The Processor - Clevo P170EM Service Manual

Removing and Installing the Processor

Processor Removal Procedure
1. Turn off the computer, remove the battery
2. Remove screws - from the heat sink unit in the order indicated on the label (i.e screw 4 first through to screw
1 4
1 last Figure 13a)
.
3. Carefully (it may be hot) remove the heat sink unit
a.
2
1
4 3
b.
5
(page 2 - 5), and component bay cover
( Figure 13b)
5
.
Note: Loosen the screws in the reverse order
4-3-2-1 as indicated on the label.
(page 2 - 10).
Removing and Installing the Processor 2 - 17
Disassembly
Figure 13
Processor
Removal
Procedure
a. Remove the screws
in the correct order.
b. Carefully remove
the heat sink unit.

CPU Warning
In order to prevent
damaging the contact
pins when removing
the CPU, it is neces-
sary to first remove the
WLAN module from
the computer.

5. Heat Sink Unit
• 4 Screws