Dell C5765dn User Manual page 565

Status Code
016-709
[Cause]
[Remedy] Contact Customer Support at dell.com/contactdell.
016-711
[Cause]
[Remedy] Take one of the following measures, and then try sending the mail again.
016-712
[Cause]
[Remedy] Increase the resolution or scan area.
016-713
[Cause]
[Remedy] Enter the correct passcode.
016-714
[Cause]
[Remedy] Create a new folder or specify an existing folder.
016-715
[Cause]
[Remedy] Enter the correct password of the ESCP form.
016-716
[Cause]
[Remedy] Delete unnecessary files and users from the hard disk.
Refer to "Printing and Deleting Stored Jobs" (P.182)
016-717
[Cause]
[Remedy] Take one of the following measures:
016-718
[Cause]
[Remedy] Reduce the resolution, or cancel 2 sided printing or N up feature, and then print again.
016-719
[Cause]
[Remedy] Increase the size of the print page buffer.
016-720
[Cause]
[Remedy] Confirm the print data and try printing again.
016-721
[Cause]
[Remedy] For 1), when printing by the Auto Paper selection, set one of the paper types to other
Refer to "Paper Type Priority" (P.302).
An error occurred during print processing.
The upper limit for the e-mail size has been exceeded.
• Reduce the number of pages of the document.
• Lower the resolution with [Resolution].
• Reduce the magnification with [Reduce / Enlarge].
• Ask your system administrator to increase the value set for [Maximum Total Data
Size].
• For color scanning, set [MRC High Compression] to [On] under [File Format].
Unable to process the document because the specified scan area is too small.
The passcode entered does not match the passcode set on the folder.
The specified folder does not exist.
The machine failed to access the ESCP form because the password of the ESCP form
does not match.
Unable to spool TIFF file because of insufficient hard disk space.
Unable to create a Transmission Report - Job Undelivered or a Transmission Report
because the transmission result information required for creating the report is not stored
in the machine's memory.
• If many scan documents are being processed, wait until the jobs are completed to
execute a new job.
• After completing the job that you want to confirm in a report, do not execute 200 or
more jobs before printing the report.
Unable to process the PCL print data because of insufficient memory.
Unable to process the PCL print data because of insufficient print page buffer.
An invalid command is included in PCL print data.
An error occurred during print processing. Probable causes are as follows:
1)Printing was instructed by the Auto Paper selection when [Paper Type Priority] is set
to [Auto Paper Off] for all paper in the [Common Service Settings].
2)ESC/P-K command error occurred.
than [Auto Paper Off] in [Paper Type Priority].
For 2), confirm the print data.
Cause and Remedy
Status Code
565