Glass Assembly; Screen Mesh; Grilles And Trim; Air Shutter Setting - Heat & Glo 6000G Owner's Manual

F. Glass Assembly
WARNING
Handle glass doors with care.
• Inspect the gasket to ensure it is undamaged.
• Inspect the glass for cracks, chips or scratches.
• Do NOT strike, slam or scratch glass.
• Do NOT operate appliance with glass door removed,
cracked, broken or scratched.
• Replace glass door assembly as a complete appliance.
Removing Glass Assembly
Pull the four glass assembly latches out of the groove on
the glass frame. Remove glass door from the appliance
(see Figure 12.14).
Replacing Glass Assembly
Replace the glass door on the appliance. Pull out and
latch the four glass assembly latches into the groove on
the glass frame.
LATCHES
(BOTH BOTTOM
AND TOP)
GLASS
ASSEMBLY
Figure 12.14 Glass Assembly
46 Heat & Glo • 6000G, 6000G-IPI • 2103-900 Rev. M • 9/08
G. Screen Mesh
Screen mesh is supplied with the optional doors.
H. Grilles and Trim
Install optional marble and brass trim surround kits as
desired. Marble, brass, brick, tile, or other noncombustible
materials can be used to cover up the gap between the
sheet rock and the appliance.
Do not obstruct or modify the air inlet/outlet grilles.
I. Air Shutter Setting
This appliance has an adjustable air shutter (which controls
the primary air) factory set for the minimum vertical vent
run (see Figure 12.15). If your installation has more than
the minimum required vertical vent length, adjustment of
the air shutter may be necessary to obtain optimal fl ame
appearance. This should be adjusted by a qualifi ed
installer at the time of installation.
By pushing the air shutter handle in, you will be closing
the air shutter. To adjust loosen the wing nut. Care should
be taken when adjusting the air shutter so as not to cause
the appliance to soot. If sooting occurs the air shutter will
need to be opened by pulling the handle out. When fi nished
tighten wing nut.
Figure 12.15
Shutter Settings
Burner
AIR SHUTTER
WING NUT
NG LP
1/8 in. Full Open