Appliance Preparation; Top Vent - Heat & Glo 6000G Owner's Manual

7 7

Appliance Preparation

A. Top Vent
Figure 7.1 For top vent, remove the two screws holding the
elbow heat shield in place. Use this heat shield over the
fi rst elbow if applicable. For rear vent skip this step.
Figure 7.2 Cut the seal cap strap across the rectangles
next to the disk.
Figure 7.3 Remove the white gasket material covering
the seal cap.
Heat & Glo • 6000G, 6000G-IPI • 2103-900 Rev. M • 9/08
Figure 7.4 Fold the center parts of the retaining band up
and use to remove the vent cap.
Figure 7.5 Discard the vent cap, remove and discard
the insulation basket. Note: Once the vent cap has been
removed it cannot be reattached.
Proceed to Section 7. C.
CAUTION
Sharp Edges
• Wear protective gloves and safety
glasses during installation.
25