Routine Maintenance; Maintenance-Features Summary - Xerox PHASER 8560 Brochure

Ease of Use Ease of Use

ROUTINE MAINTENANCE

Workgroup devices sold through retail and traditional IT
distribution outlets usually are maintained by office
workers who change the all-in-one cartridge units that
encase the entire imaging system, including the toner
cartridge. Units sold through resellers and dealers are
usually maintained by office workers and/or trained
service engineers. While separate long-life parts are more
complex to install (i.e., separate toner cartridges, imaging
drums, transfer belts), they tend to cost less than low-
yield, all-in-one alternatives.
Toner Replacement
Changing the toner or imaging cartridge is a necessary
task that traditionally is avoided by some for fear of toner
dust leaking on clothing or hands. However, most units
today offer clean replacement of toner supplies, and there
is very little risk of toner leakage.
Clearing Paper Misfeeds
The main issue that office users attempt to avoid is the
removal of an occasional paper misfeed. As a general
rule, the faster a device engine, and the more paper
handling and finishing options it has, the more complex is
the process of removing paper misfeeds.
Common paper-misfeed sources involve the duplex unit
and poor loading of paper supplies. The position of the
duplex unit may be a major factor in the removal of many
paper misfeeds. How easy or difficult it is to load paper
supplies can also be a factor in the overall number of
misfeeds that may occur
Loading Paper
It goes without saying that loading paper should be as
easy as possible, but sometimes this not the case.
Among the factors that affect ease-of-use are:
•
The user should be able to load an entire ream (500
sheets) in a single step.
•
Mechanisms such as corner separators and ramps in
the paper drawer can impede loading paper.
•
The most critical factor involved in ease-of-loading
paper is automatic paper-size detection. Ultimately,
the device should be able to recognize the new paper
size and reflect it on its control panel/touch screen
and across the network in print drivers, printer-
management software. Without automatic paper-size
detection, users must remember to program-in the
new paper size—something they often neglect to do
or do incorrectly. This can result in jobs printed on the
wrong paper size, backed-up job logs, etc.
Copyright © 2007 MCA Internet, LLC dba BERTL.
All Rights Reserved. The license under which this document is made available and applicable law prohibit any reproduction or further transmission of any portion of this document. This
document may only be viewed electronically through the www.BERTL.com Web site and may not be stored in electronic or hard copy format. Any reproduction of trademarks is strictly
prohibited. BERTL accepts no responsibility for any inaccuracies or omissions contained in this document.

Maintenance-Features Summary

*Black Ink-Stick Yield
*Color Ink-Stick Yield
Imaging Unit Life
Fuser Life
Developer Life
Ink Refill During Printing?
User Replaceable Imaging Unit?
User Replaceable Fuser Unit?
User Replaceable Waste Container?
User Replaceable Original/Paper Feed
Rollers?
*Manufacturer's stated toner yield using originals with 5% area
coverage per color
A flashing red LED on the control panel alerts users that
the printer is in need of attention
May 2007
Xerox Phaser 8560
www.bertl.com
3,400 pages;
high-yield black
stick rated to
yield 6,800 pages
3,400 pages
Not applicable
Not applicable
Not applicable
Yes
Not applicable
Not applicable
Yes
No
.
13 April 2007
Page 15