Step 10. Installing Trim, Logs & Ember Material; Installing The Trim; Positioning The Logs; Attachment Of Lower Door Assembly - Heat & Glo LCOR-HVB-CE Installer's Manual

Step 10. Installing Trim, Logs & Ember Material

Installing the Trim

Combustible materials may be brought up to the specified
clearances on the side and top front edges of the fireplace,
but MUST NEVER overlap onto the front face. The joints
between the finished wall and the fireplace top and sides
can only be sealed with a 149° C minimum sealant.
WARNING: WHEN FINISHING THE FIREPLACE,
!
NEVER OBSTRUCT OR MODIFY THE AIR INLET/
OUTLET GRILLES IN ANY MANNER.
Install optional marble and brass trim surround kits as
desired. Marble, brass, brick, tile, or other non-combustible
materials can be used to cover up the gap between
combustible material (sheetrock or wood) and the fireplace.
Do not obstruct or modify the air inlet/outlet grilles. When
overlapping on both sides, leave enough space so that the
bottom grille can be lowered and the trim door removed.
WARNING: CHILDREN AND ADULTS SHOULD
!
BE ALERTED TO THE HAZARDS OF HIGH
TEMPERATURES OF WORKING SURFACES ON
THESE HEATERS. WORKING SURFACES INCLUDE
ALL GLASS PANELS AND DECORATIVE DOORS.
YOUNG CHILDREN SHOULD BE CAREFULLY
SUPERVISED WHEN THEY ARE IN THE SAME
ROOM AS THE APPLIANCE.
Log placement
Log Set Assembly: LOGS-ST-CE
Only for Models: ST-HVB-CE, PIER-HVB-CE and RCOR-HVB-CE
1
2 3
CAUTION: Logs are fragile. Carefully remove the logs from the packaging. Logs #4 and #5 are the same log.
See Service Parts pages for individual assembly photos.
4
6
5
Heat & Glo • PIER/ST/L&RCOR-HVB-CE • 2068-900 Rev. H • 6/07

Attachment of Lower Door Assembly

This unit is shipped with the door stops unattached to assist
in the set-up of the unit. After the gas and electrical have
been run, the door stops can be used if desired as shown
in Figure 32.
DOOR
STOPS
SHOULDER
BOLT
LOWER
DOOR
Figure 32. Lower Door Assembly
TABS
SHOULDER
DOOR
BOLT
STOPS
35