Glass Assembly; Air Shutter Setting - Heat & Glo Grand-XTS Installation Manual

F. Glass Assembly
WARNING
Handle glass doors with care.
• Inspect the gasket to ensure it is undamaged.
• Inspect the glass for cracks, chips or scratches.
• Do NOT strike, slam or scratch glass.
• Do NOT operate appliance with glass door removed,
cracked, broken or scratched.
• Replace glass door assembly as a complete appliance.
Removing Glass Assembly
The glass assembly fastens to the fi replace in four places.
Two or four of the fastening mechanisms will be spring-
loaded glass latches, depending on the model. An ex-
ample of the glass latch is shown in Figure 11.5.
Supreme-XTS
To release glass assembly, pull the two bottom spring-
loaded latches forward and allow them to retract away from
the glass assembly. Remove glass assembly by carefully
pulling the bottom side of the glass assembly out fi rst.
Carefully slide the glass assembly outward and downward
until the top tabs are disengaged from the slots.
Grand-XTS
To release glass assembly, pull the two bottom spring-
loaded latches forward and allow them to retract away from
the glass assembly. Slide the glass assembly outward and
downward until the top latches disengage.
Replacing Glass Assembly
Supreme-XTS
Tilt glass assembly toward fireplace and slide glass
assembly up to engage top two tabs with the corresponding
slots. Fasten the two bottom latches.
Grand-XTS
Tilt glass assembly toward fi replace and slide glass as-
sembly upward to engage top latches. Verify top latches are
fully engaged and then fasten the two bottom latches.
Heat & Glo • Supreme-XTS, Grand-XTS • 349-901 Rev. G • 9/08
Figure 11.5 Glass Assembly
G. Air Shutter Setting
Optimal fl ame appearance is dependent on the air shutter
setting. Adjustments should be made by a qualified
technician.
Model
Grand-XTS 1/2 in.
Supreme-XTS 3/8 in.

GLASS ASSEMBLY

BOTTOM LATCH
NG LP
Full Open (3/4 in.)
Full Open (3/4 in.)
27