Heat & Glo GRL-700-AU Installation And Operation Instructions Manual

Hearth and home technologies gas log sets manual grl-700-au

Advertisement

AUSTRALIAN GAS ASSOCIATION APPROVED
THIS MANUAL MUST BE USED FOR INSTALLATION AND RETAINED
BY HOMEOWNER FOR OPERATION AND MAINTENANCE.
HEAT-N-GLO, a brand of Hearth & Home Technologies Inc.
20802 Kensington Boulevard, Lakeville, MN 55044, U.S.A. • (952) 985-6000
This product is covered by one or more of the following patents: (United States) 4,112,913; 4,408,594; 4,422,426; 4,424,792; 4,520,791; 4,793,322; 4,852,548; 4,875,464;
5,000,162; 5,016,609; 5,076,254 5,191,877; 5,218,953; 5,328,356; 5,429,495; 5,452,708; 5,542,407; 5,613,487; (Australia) 543790; 586383; (Canada) 1,123,296; 1,297,746;
2,195,264; (Mexico) 97-0457; (New Zealand) 200265; or other U.S. and foreign patents pending.

INSTALLATION AND OPERATION

INSTRUCTIONS
MODEL: GRL-700-AU
Approval Number 5669
1
2010-900C 7/03

Advertisement

Table of Contents
loading

Summary of Contents for Heat & Glo GRL-700-AU

  • Page 1: Installation And Operation

    INSTALLATION AND OPERATION MODEL: GRL-700-AU AUSTRALIAN GAS ASSOCIATION APPROVED THIS MANUAL MUST BE USED FOR INSTALLATION AND RETAINED BY HOMEOWNER FOR OPERATION AND MAINTENANCE. HEAT-N-GLO, a brand of Hearth & Home Technologies Inc. 20802 Kensington Boulevard, Lakeville, MN 55044, U.S.A. • (952) 985-6000 This product is covered by one or more of the following patents: (United States) 4,112,913;...
  • Page 2 INSTALLATION AND OPERATION INSTRUCTIONS PLEASE READ THIS MANUAL BEFORE INSTALLING MODEL GRL-700-AU IS AUSTRALIAN GAS ASSOCIATION APPROVED FOR NATURAL GAS OR PROPANE AS A DECORATIVE GAS LOG. Refer to the appliance data plates for gas consumptions and pressures. Installation of this appliance should only be...
  • Page 3: Table Of Contents

    INTRODUCTION ...5 ASSEMBLY...5 GAS LINE CONNECTION ...6 LOG PLACEMENT ... 7 OPERATING GUIDELINES AND MAINTENANCE INSTRUCTIONS ...10 SAFETY INFORMATION...11 LIGHTING INSTRUCTIONS ...12 REPLACEMENT PARTS: ...13 WARRANTY POLICY ...15 u = Contains updated information. Table of Contents...
  • Page 4 PILOT ASSEMBLY BURNER PIEZO IGNITOR GRATE CONTROL ACCESS COVER TOP VIEW - FIREPLACE AREA DEPTH TOP VIEW WIDTH FIREPLACE OPENING Minimum WIDTH: 700mm DEPTH: 300mm HEIGHT: 425mm FIGURE 1 ON/OFF SWITCH 33mm MINIMUM Maximum 1050mm 460mm 540mm FRONT SUROUND REAR SURROUND FLEX TUBE VALVE...
  • Page 5: Introduction

    INTRODUCTION Model GRL-700-AU Gas Log Sets are Decorative Gas Appliances for Installation in a Solid-Fuel Burning Fire- place. Minimum fireplace size for GRL-700-AU: height 425mm, width 700mm, depth 300mm. This log set is to be installed only in a solid-fuel burn-...
  • Page 6 A. Inlet gas supply pressure for purposes of input ad- justment, shall be 6.0 inches w.c. (1.5kPa) for natu- ral gas and 11 inches w.c. (2.75kPa) for propane. Manifold (outlet) pressure should be 3.2 inches w.c. (.80kPa) for natural gas and 9.6 inches w.c. (2.40kPa) for propane models.
  • Page 7: Log Placement

    Log Set Assembly: GRL-700-AU-LOGS Model: GRL-700-AU STEP 1: Attach grate to as- sembly by sliding hooks into open- ings on the front surround. STEP 2: Ensure that tabs on front and rear surrounds are bent as shown in Figure 1. Carefully remove logs from carton and place as shown.
  • Page 8: Natural Gas

    Heat-n-Glo GRL-700/GRL-850 Glowing Embers • Place single layer of 10mm circular sized pieces next to burner ports, taking care not to place material on or between ports. • Do not use all of the ‘ember’ in the packet. One packet should last 5-6 applications. •...
  • Page 9 Heat-n-Glo GRL-700/GRL-850 Glowing Embers (Mineral Wool) Placement • Place single layer of 10mm circular sized pieces on top of burner ports. • Increase the quantity of the “glowing embers” on the right, centre and left hand side, as indicated, of the burner where there is a cluster of burner ports.
  • Page 10 STEP 3: LOG #1 (SRV506-701) Put log #1 behind the locating tab on the right rear corner and up against the locating tab in the center. STEP 4: LOG #2 (SRV2010-703) Place log #2 on the right front corner of the unit using its locating slots (on log bottom). STEP 5: LOG #3 (SRV506-717) Place log #3 against the left front corner of log #2 as shown.
  • Page 11 330mm STEP 6: LOG #4 (SRV591-703) Rest log #4 in between the locating tabs on the rear shelf and rest its front top 330mm from the left corner of the decorative front. STEP 7: LOG #5 (SRV550-714) Rest log #5 against log #3 and rest its right edge on log #1. STEP 8: LOG #6 (SRV530-716) Place log #6 in the groove on top of log #2 with its front on log #1.
  • Page 12: Operating Guidelines And Maintenance Instructions

    OPERATING GUIDELINES AND MAINTENANCE INSTRUCTIONS Upon completing the gas line connection, a small amount of air will be in the lines. When first lighting the pilot light, it will take a few minutes for the lines to purge themselves of this air. Once the purging is com- plete, the pilot and burner will light and operate as indi- cated in the instruction manual.
  • Page 13: Safety Information

    SAFETY INFORMATION FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROP- ERTY DAMAGE, PERSONAL INJURY, OR LOSS OF LIFE. A. This appliance has a pilot which must be lighted by hand.
  • Page 14: Lighting Instructions

    LIGHTING INSTRUCTIONS 1. "STOP!" Read the safety information on previous page. 2. Remove the control access cover. 3. Turn the valve control knob to the "OFF" position. To do this, you must turn the knob clockwise to the "Pilot" position, and then press in and continue turning clockwise to the "OFF"...
  • Page 15: Service Parts

    GRL-700-AU Service Parts (NG, LP) Exploded Parts Diagram Beginning Manufacturing Date: 4-2003 Ending Manufacturing Date: ________ Log set assembly Part number list on following page.
  • Page 16: Replacement Parts

    4.0 REPLACEMENT PARTS: GRL-700-AU When requesting service or replacement parts for your decorative gas log set, please provide model number and serial number. All parts listed in this manual may be ordered from an authorized dealer. ITEM ON/OFF Rocker Switch...
  • Page 17 LIMITED 10 YEAR WARRANTY HEAT-N-GLO, a brand of Hearth & Home Technologies Inc. In order to presumptively establish the dates to which your HEAT-N-GLO Limited Warranty runs, you must mail the completed warranty card to HEAT-N-GLO, a brand of Hearth & Home Technologies Inc., 20802 Kensington Boulevard, Lakeville, MN 55044, within 60 days of the date of the fireplace installation.

Table of Contents