Roland Cakewalk A-500S Owner's Manual page 15

6.
The screen will indicate "A-500S Driver will be installed on your computer."
Click [Next].
* If any other message appears, proceed as directed by the message.
7.
To begin the installation, click [Next] once again.
Installation will begin.
If a dialog box related to Windows Security appears, click [Install].
fig.vista-7e.eps
The screen will indicate "Ready to install the driver."
* If any other message appears, proceed as directed by the message.
8.
Operation of the A-500S
* If the [ADVANCED DRIVER] switch is set to OFF, the installation will not take place as described in the following
procedure.
* Once the connections have been completed, turn on power to your various devices in the order specified. By turning
on devices in the wrong order, you risk causing malfunction and/or damage to speakers and other devices.
9.
Operation of the A-500S
10.
Operation of the A-500S
11.
Operation of the A-500S
The driver will be installed automatically.
* It can take several minutes for the driver installation to complete.
* This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up is required before the unit
will operate normally.
12.
When installation has been completed, the Driver Setup dialog box will indicate "Installation has been
completed."
Click [Close] to close the Driver Setup dialog box.
If the System Settings Change dialog box appears, click [Yes]. Windows will automatically restart.
Next, you need to set your software so it can use the A-500S.
Set the A-500S's [ADVANCED DRIVER] switch to the ON position.
Set the A-500S's power switch to the OFF position.
Use a USB cable to connect the A-500S to your computer.
Set the A-500S's power switch to the USB position.
Driver Installation and Settings
15