Fujitsu PRIMERGY RX200 S6 Options Manual page 70

Further options
Ê Open the server as described in the
Figure 40: Installing the TPM module
Ê Insert the TPM spacer into the hole on the system board (1).
Ê Insert the TPM on the system board (2).
Ê Fasten the TPM with the special screw for the TPM (3).
Please use the TPM screwdriver insert bit to tighten the special screw.
I
Do not fasten the screw too tightly (torque value of 0.6 Nm).
Ê Close the server, connect it to the power outlet, and s witch it on as described
in the chapter "Completion" on page
I
You can find information on configuring the TPM in the "D3031 BIOS
Setup Utility for RX200 S6" manual.
70
chapter "Preparation" on page
1
3
2 2
3 1
73.
Options Guide
25.
RX200 S6