Connecting iBBU cable to RAID controller in riser card #1
Figure 38: Routing the iBBU cable to RAID controller in riser card #1
Ê Route the iBBU cable as shown.
I
The iBBU cable must pass under the riser card holder with riser card
#3 (see cabling plan on
Ê Connect the free connector of the iBBU cable to the corresponding
connector on the RAID controller (see circle).
I
The connector is protected against polarity reversal, in other words,
the connector can only be connected one way round.
Ê Close the server, connect it to the power outlet, and switch it on as described
in the
chapter "Completion" on page
RX200 S6
page
81).
73.
Options Guide
Expansion cards and iBBU
67