Fujitsu PRIMERGY RX200 S6 Options Manual page 38

Processors
Figure 10: Installing the heat sink
Ê Remove the protective cover on the underside of the heat sink.
V
CAUTION!
Do not touch the thermal paste on the underside of the heat sink.
Ê Place the heat sink on the processor as shown.
Ê Fasten the heat sink by tightening the four screws in a crossover pattern (see
circles).
V
CAUTION!
Never install a processor without a heat sink as otherwise the processor
may overheat, causing the possible failure of the processor and system
board.
Ê Reinstall the air duct as described in the
page 73.
Ê Close the server, connect it to the power outlet, and s witch it on as described
in the chapter "Completion" on page
38
section "Installing the air duct" on
73.
Options Guide
RX200 S6