Fujitsu PRIMERGY RX200 S6 Options Manual page 65

Connecting iBBU cable to modular RAID controller in riser card #3
Figure 36: Routing the iBBU cable to modular RAID controller in riser card #3
Ê Route the iBBU cable as shown.
I
The iBBU cable must pass beneath the power cable that crosses the
iBBU cable.
Ê Connect the free connector of the iBBU cable to the corresponding
connector on the modular RAID controller (see circle).
I
The connector is protected against polarity reversal, in other words,
the connector can only be connected one way round.
Ê Close the server, connect it to the power outlet, and switch it on as described
in the chapter "Completion" on page
RX200 S6
73.
Options Guide
Expansion cards and iBBU
65