Fujitsu PRIMERGY RX200 S6 Options Manual page 60

Expansion cards and iBBU
Figure 30: Riser card holder #2 equipped with an expansion card
Ê Insert the expansion card into the riser card of the same height.
I
Make sure that the rear slot cover is positioned in the designated
groove.
Ê If necessary, connect the cables to the expansion card and the other
components.
Installing an expansion card in riser card #3
See section "Installing a modular RAID controller" on page
Reinstalling the riser card holder
Ê Position the riser card holder over the relevant slot on the system board.
Ê Carefully push the riser card holder into the slot by pressing on the green
points.
Ê Close the server, connect it to the power outlet, and s witch it on as described
in the chapter "Completion" on page
60
73.
Options Guide
61.
RX200 S6