Fujitsu PRIMERGY RX200 S6 Options Manual page 51

Removing the existing HDD backplane (6x HDD)
Ê Remove all HDD modules from the housing.
Figure 21: Removing the HDD backplane
Ê Disconnect all cables from the HDD backplane (see circle).
Ê Lift the HDD backplane over the metal bars (see arrows) and then remove it.
Installing the new HDD backplane (8x HDD)
Ê Place the new HDD backplane (8x HDD) on the metal bars (see arrows in
figure 21) and press the HDD backplane down carefully.
Ê Connect all the required cables to the HDD backplane (see
for up to 8 HDD modules with optional RAID controller" on page
RX200 S6
Options Guide
HDD modules
figure "Cabling
80).
51