Rear Panel - NETGEAR ProSafe SRX5308 Reference Manual

ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Table 1. LED descriptions (continued)
LED Activity
WAN Ports
Left LED On (green)
Blinking (green)
Off
Right LED On (green)
On (amber)
Off
Internet LED On (green)
Off

Rear Panel

The rear panel of the VPN firewall includes a console port, a reset button, a cable lock
receptacle, an AC power connection, and a power switch.
Reset button
Console port
Figure 2.
Viewed from left to right, the rear panel contains the following components:
1. Cable security lock receptacle.
2. Console port. Port for connecting to an optional console terminal. The ports has a DB9 male
connector. The default baud rate is 9600 K. The pinouts are: (2) Tx, (3) Rx, (5) and (7) Gnd.
For information about accessing the command line interface (CLI) using the console port,
see Using the Command-Line Interface
3. Factory default reset button. Using a sharp object, press and hold this button for about eight
seconds until the front panel Test light flashes to reset the VPN firewall to factory default
settings. All configuration settings are lost, and the default password is restored.
4. AC power receptacle. Universal AC input (100–240 VAC, 50–60 Hz).
5. A power on/off switch.
Description
The WAN port has a valid connection with a device that provides an
Internet connection.
Data is being transmitted or received by the WAN port.
The WAN port has no physical link, that is, no Ethernet cable is
plugged into the VPN firewall.
The WAN port is operating at 1000 Mbps.
The WAN port is operating at 100 Mbps.
The WAN port is operating at 10 Mbps.
The WAN port has a valid Internet connection.
The WAN port is either not enabled or has no link to the Internet.
Security lock
receptacle
on page 253.
Introduction
16
Power
Switch
AC power
receptacle